Answer:
20g
Explanation:
hope helpful.............
Fill in the blank:
A correctly written hypothesis uses an ____ ______ statement
Answer:
a theory of a experiment and the experiment acts like a judge determining if the hypothesis is right or wrong from the final test result
Explanation:
according to the arrhenius concept, if naoh were dissolved in water, it would act as
Answer:
base
Explanation:
The substance NaOH will be disassociated in ions of Na and OH.
Ahrrenius concept of base it's anything that dissolved in water produces OH.
How far do you think a plate can move in one day?
why is it hotter in the summer and colder in the winter?
Answer: During the summer, the sun's rays hit the Earth at a steep angle. ... Also, the long daylight hours allow the Earth plenty of time to reach warm temperatures. During the winter, the sun's rays hit the Earth at a shallow angle. These rays are more spread out, which minimizes the amount of energy that hits any given spot.
Which is the correct measure of density?
Cm^2/g
g/cm^3
cm^3/g
mass x volume
Answer:
g/cm^3
Explanation:
Density= m/v
gram is a measurement of mass
cm^3 is a measurement of volume
Hope this helps:) Have a good day!
plizzz helpppp
consider the photo
which of the following best describes a single replacement reaction?
two elements combine to form a compound
one element takes the place of another in a compound
two elements switch places in a compound
a compound breaks into separate elements
Answer:
One element takes the place of another in a compound
Explanation:
I just took a test for it and got it right. :)
Hope This Helps :)
a 7.221 g sample of a compound contains 1.990 g carbon, 2.341 g hydrogen, and the rest is oxygen. Determine the
percent composition of the compound
Answer:
17.19%
Explanation:
mass of oxygen = 7.221 - (1.990 + 2.341)
= 2.890g
Empirical formula of the compound
For carbon,
1.990/12 = 0.1658
For hydrogen,
2.341/1 = 2.341
For oxygen,
2.890/16 = 0.1806
0.1658 ÷ 0.1658 = 1
2.341 ÷ 0.1658 = 14.11
0.1806 ÷ 0.1658 = 1.089
Empirical formula of the compound= CH14O
Molar mass= (1×12) + (14×1) + (1×16)
= 12+14+16
= 42g/mol
percentage composition= 7.221/42 × 100
= 17.19%
If you run a refrigerator in a closed room with the refrigerator door open,the room temperature willA) increase.B) decrease.C) remain unchanged.
Answer: A increase
Explanation: The temperature of room will increase. If a refrigerator door is open then more flow rate of coolant is required in order to maintain lower temperature So the compressor will be running continuously also heat exchange happening through condenser increases the room temperature rather than decreasing.
What is the significance of cell division?
A. to make ATP
B. to prevent replication
C. to repair and replace other cells
D. to make glucose
Explain what happens to water during electrolysis. Is this a chemical reaction or phase change?
By definition, electrolysis is the use of an electric current to cause a chemical reaction which wouldn't otherwise happen. In a chemical change, bonds are either broken or formed. Electrolysis is a chemical change because, in the process of electrolysis, bonds are broken or formed.
Write the complete electron configuration using the diagonal rule for strontium.
5 Stoichiometry Chemistry questions !
1. Determine the mass in grams of lithium hydroxide produced when 0.38 g of lithium nitride reacts. g LiOH
Li3N(s) + 3 H2O(l) --> NH3(g) + 3 LiOH(aq)
2. How many moles of sodium chloride are produced when 2.9 grams of sodium iodide reacts? mol NaCl
2 NaI(s) + Cl2(g) --> 2 NaCl(s) + I2(g)
3. What volume in liters of chlorine gas at STP would be required to fully react with 125 g of NaI? L Cl2
2 NaI(s) + Cl2(g) --> 2 NaCl(s) + I2(g)
4. Determine the volume in liters of carbon dioxide produced at STP when 0.85 grams of butane (C4H10) reacts. L CO2
2 C4H10(l) + 13 O2(g) --> 8 CO2(g) + 10 H2O(g)
5. Calculate the mass in grams of water vapor produced by the combustion of 51.3 L of propane, C3H8, at STP. g H2O
C3H8(g) + 5 O2(g) --> 3 CO2(g) + 4 H2O(g)
which two observers would be experiencing the same apparent solar time?
The observers which would experience the same apparent solar time are observer B and observer E. This means the correct response as per the full question indicated in the attached document is number 2.
Types of Solar TimeThere are two types of Solar Time. They are:
Apparent Solar Time and Mean Solar TimeWhat is Apparent Solar Time?Apparent solar time refers to the time of the day that is shown by the hour angle of the sun. It is also defined as the sun's position in the sky going by direct observation. Direction observation of the sun to determine Solar Time is possible using a Sundial.
See the link below for more about Apparent Solar Time:
https://brainly.com/question/6336054
what would u add if the soil is too basic~~ ?
Slaked lime is the ans
thank me later : p
help i cant do this i need this ASAP
Answer:
you draw the line first to the light bulb and then you connect it to the battery then you connect it to microscope
Explanation:
hope this helped pls mark it brainlest pls and thank you:)
Why is it important to be careful when walking on an icy sidewalk?
Ice moves faster than you do.
There is less friction on an icy surface.
Ice is heavier than you, so it is a greater force.
none of the above
Answer:
The is less friction on an icy surface
Explanation:
This is because when u walk on plain ground there is steady friction on the surface but when u walk on an icy floor these is barely any friction which is why it's hard to walk on.
Answer:
There is less friction on an icy surface.
Hope that helps.
Explanation:
what is the three-dimensional coordination number of the face-centered cubic arrangement?
The three-dimensional coordination number of the face-centered cubic arrangement has a coordination number of 12 and contains 4 atoms per unit cell.
What is coordination number ?The coordination number, also known as ligancy, of a central atom in a molecule or crystal is the sum of all the atoms, molecules, or ions that are linked to it. This value is used in crystallography and materials science. A ligand is the ion, molecule, or atom that surrounds the center ion, molecule, or atom.
The number of atoms, ions, or molecules that a central atom or ion bears in a complex or coordination compound or in a crystal as its near neighbors is known as the coordination number, also known as ligancy.
In contrast to oxidation state, which is a number assigned to an element in chemical combination and represents the number of electrons lost or gained by an atom of that element in the compound, co-ordination number is the number of co-ordination bonds with which the ligands are bound to the central ion.
Thus, the face-centered cubic arrangement has a coordination number of 12 and contains 4 atoms per unit cell.
To learn more about coordination number, follow the link;
https://brainly.com/question/16882931
#SPJ5
has an atomic number of 1.
There are many with atomic number 1
hydrogen , helium , lithium , beryllium etc.
Hope this answer helps you dear!.
Answer:
With atomic number 1 is hydrogen
Explanation:
The valence with 1 is hydrogen, lithium.....
Why are the melting and boiling points of an
element or a compound are called its fixed points.
Substances having fixed chemical proportions will have fixed boiling and melting points. This is the reason that Pure substances have specific melting and boiling points because their chemical proportions are fixed. Mixtures melt and boil over a range of temperatures
[tex]\large\sf\red{♡♡~}[/tex]
Q2. Fill in the blank with correct words.
A: Chemical B: Horizontal C: Shells D: Columns E: Group VII
1) The vertical ___________are called groups and the_____________rows are
called periods.
2) Elements in the same groups have the same number of electrons in their
outer_______________ for example, all the elements in ___________ have 7
electrons on their outer shells.
3) Elements in the same group have similar ___________ and physical properties
Answer:
Explanation:
1) The vertical Columns are called groups and the Horizontal rows are
called periods.
2) Elements in the same groups have the same number of electrons in their
outer Shells for example, all the elements in Group VII have 7
electrons on their outer shells.
3) Elements in the same group have similar Chemical and physical properties
Explanation:
1) Columns
Horizontal
2)Shell
Group VII
3)Chemical
What is the process that results in the formation of an ion
When water changes state from solid to liquid to gas, ALL BUT one thing happens. There is no
A) chemical change.
B) physical change.
C) addition of energy.
D) increase in temperature.
Which subatomic particles have a positive charge and are located in the nucleus?
a. neutrons
b. atoms
c. electrons
d. protons
Answer: protons
Explanation:
a) Neutrons are located in the nucleus but have a negative charge.
b) Atoms are not subatomic particles but are rather made of subatomic particles.
c) Electrons are subatomic particles with a negative charge that are located outside of the nucleus.
d) Protons are subatomic particles that are located in the nucleus and have a positive charge.
explain a mixture of molecules
Answer:
A mixture of molecules is a group of molecules in which there are multiple different elements and atoms, that are in either fixed proportions or random. There are heterogeneous and homogenous mixtures.
Explanation:
most common elements that bond with oxygen
Explanation:
most common elements that bond with oxygen is Hydrogen (H2) to form water
Maximum s-character is observed in
a) Triple bonded carbon atom b) Double bonded carbon atom
c) Single bonded carbon atom d) Carbon atom of benzene
[tex]\huge{\underline{\underline{\boxed{\sf{\purple{ǫᴜᴇsᴛɪᴏɴ}}}}}}[/tex]
Maximum s-character is observed ina) Triple bonded carbon atom b) Double bonded carbon atomc) Single bonded carbon atomd) Carbon atom of benzene[tex]\huge{\underline{\underline{\boxed{\sf{\red{Answer}}}}}}[/tex]
Maximum s-character is observed ina) Triple bonded carbon atomPlease help me, trying to get all my hw done
Answer:
C. size and shape
Explanation:
Physical properties such as size, shape, color, density, magnetism or the
ability to sink or float can be used to separate the substances in a mixture..
Filtration is when matter is passed through a filter and the larger particles
are separated out. Magnets can be used to separate magnetic matter from
non-magnetic matter in a mixture. Objects that float when placed in water
can be separated from those that don’t by placing the mixture in water.
How can you tell the difference between two clear liquids
Answer:
To identify a pure liquid substance using the physical properties of solubility, density, and boiling point. The physical properties of a pure substance can be measured without changing the composition of the substance.
Explanation:
Find the molar mass of iron (III) nitrate, Fe(NO3)3
Answer:
Hey there are you doing are you doing I will tell you the answer