The Protocol Filter feature is used to block unwanted traffic from your network. The feature is commonly used to make sure employees, students or end users are using their Internet access for its intended productive use. The filter can block dozens of different protocols, including:
If you did not select this module to be included during the installation process, you must first install the module.
You can find this feature in the menu system at the following location:
<navigation>Gateway|Protocol Filter|Protocol Filter Configuration</navigation>
By default, the protocol filter displays the full list of protocols and the status of each one. Since there are well over 100 protocols defined, you can filter the display by type:
In some circumstances, you may want to allow specific systems to bypass the protocol filter system. For example, you may want to block voice-over-IP (VoIP) traffic for your entire network, except for the dedicated VoIP/PBX server. In these circumstances, you can add IP addresses to the protocol filter bypass configuration:
If your connection to the Internet is faster than 5 Mbps, we do not recommend using the protocol filter at this time. You should also be aware that not all protocol filter rules are created equal. Some rules have little effect on performance while others can have a significant impact.