Someone please help i have to get it done today

Answer:

Explanation:

We can first calculate [H⁺] by using the formula:

Now we proceed to calculate pH:

As the pH is higher than 7, the solution is basic.

Answer:

64.6% of Br and 35.4% of Sr

Explanation:

The percentage composition is obtained defining the percentage in mass of each atom in a molecule.

To solve this question we must find the mass of each atom in 1 mole:

Molar mass Br: 79.904g/mol

Molar mass Sr: 87.62g/mol

The molar mass of SrBr2 is:

79.904g/mol*2 + 87.62g/mol =

159.808g/mol + 87.62g/mol =

247.428g/mol

The percentage of Br is:

79.904g/mol*2 = 159.808g/mol / 247.428g/mol * 100

= 64.6% of Br

And percentage of Sr is:

87.62g/mol / 247.428g/mol * 100

= 35.4% of Sr

Answer:

2260 J

Explanation:

For water at its boiling point of 100 ºC, the heat of vaporization is 2260 J g-1. This means that to convert 1 g of water at 100 ºC to 1 g of steam at 100 ºC, 2260 J of heat must be absorbed by the water.

Answer:

Speed of jays increases first, again increases, decreases and then increases.

Explanation:

The speed of jays increases while moving from rest to point A and no acceleration due to constant speed. From point A to point B, the speed is continues to increase and no acceleration. From point B to point C, the speed of jays decreases and acceleration is produced in the journey due to change of speed and from point C to point D, the speed of jays again increases and acceleration is produced due to increasing the speed.

Answer:

The speed of jay's walk increases first, again increases, then it decreases and then increases due to his acceleration walk during parts A-D.

Explanation:

Answer:

because Sulphur is written as S₂

Explanation:

Answer:

Explanation:

The answer is C Liquid

Answer:

Common (industrial) uses for cadmium today are in batteries, alloys, coatings (electroplating), solar cells, plastic stabilizers, and pigments

Answer:

a closed series circuit

Answer:

An open series circuit

Explanation:

I'm late but for future people...

I took the test.

Answer:

1.Most metal oxides are insoluble in water but some of these (e.g. Na2O.

Explanation:

2.: (i) A hissing sound is observed.

1.ii) The mixture starts boiling and lime water is obtained.

Answer:

The energy changes in converting reactants to products is the same regardless of the route by which the chemical changes occur.

Answer:

vapourisation can occur from solid or liquid into a gas but evaporation is straight from a liquid and is often below boiling temperature while vapourisation is often above boiling temperature

Answer:

[tex] \huge\red{\boxed{\mathfrak{Hello}}}[/tex]

[tex]\underline\blue{\textsf{\textbf{Question-}}}[/tex]

[tex]{\huge\pink{\fbox{{࿐αɴѕωєя࿐}}}}[/tex]

[tex] \huge\green{ \mid{ \underline{ \overline{ \tt PARAMETERS: }} \mid}}[/tex]

[tex] \huge\purple{ \mid{ \underline{ \overline{ \tt VAPORIZATION: }} \mid}}[/tex]

[tex] \huge\orange{ \mid{ \underline{ \overline{ \tt EVAPORATION:}} \mid}}[/tex]

➳ ʰᵒᵖᵉ ⁱᵗ ʰᵉˡᵖˢ

[tex] \huge\pink{ \mid{ \underline{ \overline{ \tt ꧁❣ RainbowSalt2222 ࿐ }} \mid}}[/tex]

What happen if your Adrenal Glands become overprotective of underproductive?

Answer: if your adrenals becomes overproductive it will lead to a health issue known as CUSHING'S SYNDROME while when they become underproductive it will lead to a health condition known as ADDISON'S DISEASE.

Explanation:

The adrenal glands are divided into two embryologically and functionally distinct parts: the adrenal cortex and adrenal medulla.

The adrenal cortex is part of the hypothalamic - pituitary - adrenal endocrine system. Morphologically, the adult adrenal cortex consists of three layers which include:

--> The outer thin layer: this is also called zona glomerulosa. It secrets only aldosterone.

--> The inner two layers: these comprises of the zona fasciculata and zona reticularis. They both form a functional unit and secrete most of the adrenocortical hormones.

The adrenal medulla is the inner part of the adrenal gland which secrets the adrenaline and noradrenaline hormones.thry take part in sympathetic nervous system.

When the adrenal glands become a OVERPRODUCTIVE, the adrenal cortex is highly affected. This may occur due to hyperstimulation of the adrenal gland by adrenocorticotrophic hormone,either from the pituitary gland or from an ectopic source or due to largely autonomous secretion by an adrenal tumor such as an adenoma or carcinoma. The increased endogenous cortisol production leads to a disorder known as CUSHING'S SYNDROME. The clinical and metabolic features include obesity, hyperglycaemia and hypertension.

Also when the adrenal glands become UNDERPRODUCTIVE, a health condition known as ADDISON'S DISEASE may occur. This is cause any the bilateral destruction of all zones of the adrenal cortex, usually as the result of an autoimmune process or mycotic infections. The resulting decrease in cortisol production may lead to clinical features such as hypotension, hypoglycemia, nausea and vomiting.

Answer:

gO₂ = 32.32 g

Explanation:

In this case, let's write the general equation:

2H₂ + O₂ -------> 2H₂O

In this case, we can use the 1° law, which is mass conservation. If the product has 36.36 g of water, then in the reactants we should have the same 36.36 g.

According to this, we already have 4.04 of hydrogen, then the remaining to reach the 36.36 g would be:

gO₂ = 36.36 - 4.04

Hope this helps

Answer:

The metal has a high resistance to corrosion, meaning it is more durable and will nor rust easily.

Explanation:

The verb "corrode" means the condition of being damaged easily. In other words, it means that the metal or item gets worn out easily and is not long-lasting.

So, when metal is prized for its resistance against corrosion, it means that the metal is strong and does not wear out easily. It can outstand and withheld the corrosion effect longer. This means that the metal is durable and will not corrode easily.

Answer:

a. 0.66 atm

Explanation:

Pi = 750 torr = 0.99 atm. Pf = ?

Vi = 400 ml Vf = 600ml

Using PiVi = PfVf

Then 400ml × 0.99atm = Pfatm × 600ml

Solving for Pf, we have,

Pf = (400ml × 0.99atm)/600ml

Pf = 0.66atm

Answer:

mi no speak espanol

Explanation:

Answer:

[tex]\huge\colorbox{violet}{✏﹏ \: ᴀɴsᴡᴇʀ \: }[/tex]

➳The molar mass of copper (I) carbonate is 187.1 g/mol

[tex] \huge\blue{ \mid{ \underline{ \overline{ \tt ꧁❣ ʀᴀɪɴʙᴏᴡsᴀʟᴛ ²²²² ࿐ }} \mid}}[/tex]

Answer:

The digestive system is a system where our body breaks down food to acquire important nutrients. This is the same as your local recycling center because they collect and breaks the plastic down to be reused into recycled products.

The excretory system is a system where we remove excess unnecessary materials. This can be the same as the recycling center because they remove unnecessary materials (such as trash that is not meant to be recycled).

Answer:

b

Explanation:

Answer:

13

Explanation:

Answer:

It was the fifth radioactive element discovered, and is typically a colorless gas that puts off an insane glow when frozen.

Answer:

760ml of water

Explanation:

Answer: 800mL

Explanation:

20% of 1000mL is 200. 1000mL - 200mL is 800mL

Answer:

D

Explanation:

Hope it helps

#CarryOnLearning

Answer:

fluorine

Explanation:

Answer:

The element with the highest electronegativity is fluorine with a score of 4.0 (which is the highest possible)

Explanation:

I personally haven't gotten this question yet so I hope this helps you!

Answer:

Option C

Explanation:

The new method must support the law of definite proportions which means that if one mole of compound is distributed percentage wise then the sum of % share of each element must be equal to one mole of compound and this percentage distribution always remains the same in all conditions

Hence, option C is correct