Pls Answer this giveing brainilest an 20 points

Answer: 10.7 grams

Therefore, 10.7 grams of Hydrogen are necessary to fully react with 50.0 grams of Nitrogen.

Answer:

4 mol Fe

5 mol FeCl₃

Explanation:

Step 1: Write the balanced equation

2 Fe + 3 Cl₂ ⇒ 2 FeCl₃

Step 2: Calculate how much iron (Fe) is needed to produce 4 moles of FeCl₃

According to the balanced equation, the molar ratio of Fe to FeCl₃ is 2:2.

4 mol FeCl₃ × 2 mol Fe/2 mol FeCl₃ = 4 mol Fe

Step 3: Calculate how much FeCl₃ is produced when 5 moles of Fe react in excess chlorine

According to the balanced equation, the molar ratio of Fe to FeCl₃ is 2:2.

5 mol Fe × 2 mol FeCl₃/2 mol Fe = 5 mol FeCl₃

Answer:

an opposite reaction

Earth's gravity is still pulling down on the rocket. When a rocket burns propellants and pushes out exhaust, that creates an upward force called thrust. To launch, the rocket needs enough propellants so that the thrust pushing the rocket up is greater than the force of gravity pulling the rocket down.

Answer: Approximately [tex]0.48 \times 10^{-2} \ \text{ mole}[/tex]

============================================================

Explanation:

There are roughly 6.02 * 10^23 atoms in one mole of any element. So we have 6.02 * 10^23 atoms in one mole of nitrogen.

We can then do the following conversion:

[tex]\left(2.9 \times 10^{21} \ \text{ atoms of nitrogen} \right)\times \left(\frac{1 \ \text{ mole}}{6.02 \times 10^{23} \ \text{ atoms}}\right)\\\\\frac{2.9 \times 10^{21}}{6.02 \times 10^{23}} \ \text{ mole}\\\\\frac{2.9}{6.02} \times 10^{21-23} \ \text{ mole}\\\\0.48172757 \times 10^{-2} \ \text{ mole}\\\\0.48 \times 10^{-2} \ \text{ mole}\\\\[/tex]

Answer:

it is your instantaneous speed

Explanation:

Answer:

true

Explanation:

Answer:

More particles per unit volume

Explanation:

Concentration means the amount of solute in a solution. Now, the amount of solute also means the number of particles of solute present in a solution.

Hence, when we use the term "high concentration", we imply that the amount of solute present or the number of particles present in a solution is high.

Thus, at high concentration, there are more solute particles than solvent particles in a solution.

Answer: A 13.88 mL of the concentrated acid would be required to make 250. mL of a 1.00 M [tex]H_{2}SO_{4}[/tex] solution.

Explanation:

Given: [tex]M_{1}[/tex] = 18.0 M,     [tex]V_{1}[/tex] = ?

[tex]M_{2}[/tex] = 1.00 M,         [tex]V_{2}[/tex] = 250 mL

Formula used to calculate the volume of concentrated acid is as follows.

[tex]M_{1}V_{1} = M_{2}V_{2}[/tex]

Substitute the values into above formula as follows.

[tex]M_{1}V_{1} = M_{2}V_{2}\\18.0 M \times V_{1} = 1.00 M \times 250 mL\\V_{1} = \frac{1.00 M \times 250 mL}{18.0 M}\\= 13.88 mL[/tex]

Thus, we can conclude that 13.88 mL of the concentrated acid would be required to make 250. mL of a 1.00 M [tex]H_{2}SO_{4}[/tex] solution.

Answer:

catalpa

Explanation:

i took the test

Answer:

See answer below

Explanation:

AS we know that the valence for those metals X, Y, and Z are 1, 2 and 3, we can determine the formula of each compound.

1. Hydroxides.

An hydroxide is formed when an oxyde of a metal reacts with water. When this happens, the general molecular formula is:

Meₐ(OH)ₙ

Where:

a: valence or charge of the hydroxide (Which is -1)

n: valence of the metal.

Following this, the formula for X, Y and Z would be:

XOH

Y(OH)₂

Z(OH)₃

2. Sulphates

Sulphates follow a similar rule of hydroxide in the general molecular formula, but instead of having a charge of -1, it has a charge of -2 so:

Mₐ(SO₄)ₙ

So, following the rule:

X₂SO₄

Y₂(SO₄)₂ ------> YSO₄

Z₂(SO₄)₃

3. Hydrogens

Following the same rule as the previous, hydrogens works with a charge of -1, so:

MₐHₙ

Then:

XH

YH₂

ZH₃

4. Carbonates.

This follows the same rule as sulphates, with the same charge so:

Mₐ(CO₃)ₙ

Then:

X₂CO₃

YCO₃

Z₂(CO₃)₃

5. Nitrates

Follow the same rule as the hydroxides, with the same charge of -1.

Mₐ(NO₃)ₙ

Then:

XNO₃

Y(NO₃)₂

Z(NO₃)₂

6. Phosphates

In the case of phosphates, these have a charge of -3 so:

Mₐ(PO₄)ₙ

Then:

X₃PO₄

Y₃(PO₄)₂

Z₃(PO₄)₃ ----> ZPO₄

Hope this helps

Answer:

how and why elements what?? why they exist?? im gonna assume that's what you meant, so elements exist because we're all on earth and without elements, we don't have resources to live. the earth is made of elements and if there were none, we wouldn't even have a planet

Explanation:

^

Answer: Nuclei combine to form a heavier nucleus, releasing energy. ​

Explanation:   e.g two deuterium nucleus (Hydrogen-2 isotopes) forms an He nucleus and energy is released.

Nuclear fusion is when nuclei combine to form heavier nuclei, releasing energy.

Nuclear fusion is a reaction in which two or more atomic nuclei are combined to form one or more different atomic nuclei and subatomic particles (neutrons or protons). The difference in mass between the reactants and products is manifested as either the release or absorption of energy.

The release of energy with the fusion of light elements is due to the interplay of two opposing forces: the nuclear force, a manifestation of the strong interaction, which holds protons and neutrons tightly together in the atomic nucleus; and the Coulomb force, which causes positively charged protons in the nucleus to repel each other.

Nuclear fusion is also observed in stars.

To learn more about, fusion:

https://brainly.com/question/16556922

#SPJ5

Explanation:

Examples of things that are not matter include thoughts, feelings, light, and energy. Light, heat, kinetic and potential energy, and sound are non-matter because they are massless.

Answer:

False

Explanation:

Cows and other livestock release methane, which is a gas like Carbon Dioxide, but not the same thing, even though it does contribute into Carbon Dioxide.

Answer:

The answer should be A

Explanation:

because the definition of a subscript is that they indicate the number of atoms of an element present in am molecule or formula unit.

Answer:

The first choice. The rule is go left. Those subscript numbers always talk about the element to the left of them.

Explanation:

The straight forward answer is the first one.

You should always answer that when reading the chemical make up of molecules. Let's look at some examples.

C8 H18

Consider the 8. It must be describing how many carbons there are. If it was meant for the hydrogen, then what  does the 18 mean? You wouldn't know.

Now look at something a lot more complicated.

Mg3(PO4)2

Use the going left rule. That satisfies Mg doesn't it? There are 3 of them and 3 is correct.

The two at the end is also straightforward if you think about it. It must be telling you how many molecules are in the brackets. If that were not so, then you wouldn't be able to tell what it did. So there are 2 PO4

But you still have the 4 to deal with. Use the going left rule again. 4 must be telling you how many oxygens you have inside the brackets. There are 4 of them.

Answer: There are 1566 joules of heat needed to raise the temperature of 30.0 g of aluminum from 22°C to 80°C, if the specific heat of aluminum is 0.90 J/g°C.

Explanation:

Given: Mass = 30.0 g

Specific heat = [tex]0.90 J/g^{o}C[/tex]

[tex]T_{1} = 22^{o}C[/tex]

[tex]T_{2} = 80^{o}C[/tex]

Formula used to calculate the heat energy requires is as follows.

[tex]q = m \times C \times (T_{2} - T_{1})[/tex]

where,

q = heat energy

m = mass of substance

C = specific heat capacity of substance

[tex]T_{1}[/tex] = initial temperature

[tex]T_{2}[/tex] = final temperature

Substitute the values into above formula as follows.

[tex]q = m \times C \times (T_{2} - T_{1})\\= 30.0 g \times 0.90 J/g^{o}C \times (80 - 22)^{o}C\\= 1566 J[/tex]

Thus, we can conclude that there are 1566 joules of heat needed to raise the temperature of 30.0 g of aluminum from 22°C to 80°C, if the specific heat of aluminum is 0.90 J/g°C.

The question the person should ask him/herself to probably check for authenticity of the drugs is "Were laboratory tests conducted by the same company that produces the ac[tex]\cap[/tex]e medicine?". Option C. This is further explained below.

Generally, scientific study is simply defined as a method that includes making conjectures and deriving answers as logical implications from the hypotheses.

In conclusion, Were laboratory tests conducted by the same company that produces the ac[tex]\cap[/tex]e medicine should be questioned as medical companies should look to other labs for authenticity confirmation.

Read more about medicine

https://brainly.com/question/5591489

#SPJ2

Answer: 1

Decimal Answer: 1.858

In the buffer solution CH₃COOH (aq) ---> H₃O⁺(aq) + CH₃CO₂⁻(aq):

CH₃CO₂H is a base, and H₃O⁺ is its conjugate acid.

Option D is correct.

An acid is described as a molecule or ion capable of either donating a proton, known as a Brønsted–Lowry acid, or forming a covalent bond with an electron pair, known as a Lewis acid.

From the buffer solution above, H₃O⁺ is the conjugate acid because it donates a proton (H⁺) to a base CH₃CO₂H.

In conclusion, A conjugate acid, within the Brønsted–Lowry acid–base theory, is described as a chemical compound formed when an acid donates a proton (H⁺) to a base.

Learn more about acid at: https://brainly.com/question/25148363

#SPJ1

Answer:

those things that looks like cristals

Answer:

Electron affinity.

Explanation:

An atom can be defined as the smallest unit comprising of matter that forms all chemical elements. Thus, atoms are basically the building blocks of matters and as such determines or defines the structure of a chemical element.

Generally, atoms are typically made up of three distinct particles and these are protons, neutrons and electrons.

Electron affinity can be defined as the ability of an atom of a chemical element to accept or accommodate an electron.

This ultimately implies that, electron affinity is the change in energy of a neutral atom of a chemical element when an electron is added to the atom to form negative ion, thus, a neutral atom gain electron.

In Chemistry, electrons can be defined as subatomic particles that are negatively charged and as such has a magnitude of -1.

Answer: 0.8 m

Explanation:

Answer:

13.32

Explanation:

pOH=-log(0.21)=0.68

pH=14-pOH=14-0.68=13.32

Answer:

Work = 450 J

Explanation:

Force = 90N

Distance = 5m

Work = ?

The relationship between these quantities is given by the equation:

Work = Force * Distance

Work = 90 * 5

Work = 450 J

Answer:

C. 1.77x 1023

Explanation:

Not sure please correct me if im wrong

Taking into account the definition of frecuency, the statement "The number of waves that pass a point in 1 second" describes the frequency of a wave.

Frequency is the number of vibrations that occur in a unit of time. Its unit is s⁻¹ or hertz (Hz).

In other words, the frequency in wave phenomena, such as sound, electromagnetic waves (such as radio or light), electrical signals or other waves, expresses the number of times the phenomenon is repeated per unit of time. For example, if a wave repeats ten times per second, it means that it has a frequency of ten cycles per second.

Finally, the statement "The number of waves that pass a point in 1 second" describes the frequency of a wave.

Learn more about frequency:

https://brainly.com/question/1247008

https://brainly.com/question/12990032

#SPJ1