I don’t understand this

Answer: B. Objects are exposed to X-rays, which either pass through or are

absorbed by the objects.

C. A silicon chip releases electrons by the photoelectric effect,

producing an image.

Explanation:

The forest of Nepal has been described here on the basis of the levels of altitude, and different types of climate under the following vegetation zones:

Answer:Upthrust, Weight

Explanation:

The upward force is called Upthrust.

The downward force is called weight.

Whenever a body is submerged fully or partially in the liquid, it experiences an upward force that is equal to the weight of water replaced.

Answer:

c) It gets positively charged

Explanation:

If an electrically neutral body is loaded with protons so it gets positively charged because proton has positive charge. When the protons is added to the neutral body, it can't remain neutral because the quantity of positive charges increases in the nucleus and it gets positively charged while on the other hand, the atom from which protons are taken will acquire negative charge due to presence of more number of electrons and we know that electrons has negative charge.

Answer: 2.2x10^4

Explanation: in a adiabatic process pV^y = constant.

So V2=3V1 and p2 = p1 / 3^1.67 = 2.2x10^4 Pa

Answer:

7.45 Ω

Explanation:

From the question given above, the following data were obtained:

Resistor 1 (R₁) = 2.50 Ω

Resistor 2 (R₂) = 4.95 Ω

Voltage (V) = 12 V

Equivalent Resistance (Rₑq) =?

Since the resistors are in series arrangement, the equivalent resistance can be obtained as follow:

Rₑq = R₁ + R₂

Rₑq = 2.5 + 4.95

Rₑq = 7.45 Ω

Therefore, the equivalent resistance is 7.45 Ω

Answer:

The answer is all of the above

Explanation:

Answer:

D

Explanation:

Answer:

I think that the answer might be d

Answer:

D

Explanation:

If a car is moving very fast in a straight road or a highway in such a way that it has reached its limits as soon as it is going that fast it can break it limit

Answer:

Approximately [tex]4.2 \times 10^{2}\; \rm W[/tex] on average in the vertical direction (assuming that [tex]g = 9.8\; \rm N \cdot kg^{-1}[/tex].)

Explanation:

Vertical displacement of this student in [tex]6\; \rm s[/tex]: [tex]36 \times 16\; \rm cm = 36 \times (0.16\; \rm m) = 5.76\; \rm m[/tex].

Average vertical velocity of this student: [tex]v = \displaystyle \frac{5.76\; \rm m}{6\; \rm s} = 0.96\; \rm m \cdot s^{-1}[/tex].

The average vertical force that this student exerts on the ground would be equal to the weight of this student:

[tex]F = W = m \cdot g = 45\; \rm kg \times 9.8\; \rm N \cdot kg^{-1} = 441\; \rm N[/tex].

The average power of this student in the vertical direction is equal to the product of the force and velocity of this student in that direction:

[tex]P = F \cdot v = 441\; \rm N \times 0.96\; \rm m \cdot s^{-1} \approx 4.2\times 10^{2}\; \rm W[/tex].

Answer:

A) ( - 200t + 40 ) volts

B)  b) anticlockwise ,  c) anticlockwise , d) clockwise ,  e) clockwise

Explanation:

Given data:

magnetic flux (Φm) = 5.0t^2 − 2.0t

number of turns = 20

a) determine induced emf

E = - N [tex]\frac{d\beta }{dt}[/tex]

  =  - N ( 10t - 2 ) = - 20 ( 10t - 2 )

  =  - 200t + 40  volts

b) Determine direction of induced current

i) at t = 0

 E = - 0 + 40  ( anticlockwise direction )

ii) at t = 0.10

E = -20 + 40 =  20 ( anticlockwise direction )

iii) at t = 1

E = - 200 + 40 = - 160 ( clockwise direction)

iv) at t = 2

E = -400 + 40 =  - 360 ( clockwise direction )

Answer:

the type of wave

Explanation:

Description: Doppler Effect works on both light and sound objects. For instance, when a sound object moves towards you, the frequency of the sound waves increases, leading to a higher pitch. Conversely, if it moves away from you, the frequency of the sound waves decreases and the pitch comes down.

Answer:

There are several factors such as candle size, wax type, additives etc. that affect the rate of melting of candle

Explanation:

Following factors affect the rate at which the candle wax melts -

a) Candle size

b) Temperature of the surrounding environment

c) Type of wax used

d) Additives in the candle

e) Chemical structure of the wax

Answer:

Well my good friend the other person did not give U a good answer, it is actually the third one

Explanation: well it is the most logical of all the answers if you think about it and a lot of the creatures we have in the water today are thought of to have once lived on land based on the fossils we still find to this very day my friend

The energy of a single photon at the transmitted frequency is

A)3.55 × 10^(-28)J/photon

Energy of photon can be rewritten as

E=hv,

Where, h is planck's constant  

λ is the wavelength of photon  

Where f is the frequency of photon  

Thus, the energy of a single photon at the transmitted frequency obtained by using the formula, Energy (E) is equal to Planck's constant (h) times the frequency.

E=6.63×10^(-34)× 535×10^3

E =3.55 × 10^(-28) (J)

Photon energy doesn't depend on the power of radio station

Learn more about the Energy here;

https://brainly.com/question/3838760

#SPJ2

Answer:                 Their u go i found it their was about 3 pages i did not no what pages u had to do.

Explanation:

Answer:

v = 8.12 m/s

Explanation:

The centripetal acceleration of the yo-yo is given by the following formula:

[tex]a_c = \frac{v^2}{r}\\\\v^2 = a_cr\\v = \sqrt{a_cr}[/tex]

where,

v = tangential speed = ?

ac = centripetal acceleration = 200 m/s²

r = radius = length of string = 0.33 m

Therefore, using the given values in the formula, we get:

[tex]v = \sqrt{(200\ m/^2)(0.33\ m)}[/tex]

v = 8.12 m/s

Answer:

True

Explanation:

Incandescence material are those which glow on being heated above a particular point.  For example an incandescence bulb which has a filament. when the filament is heated it starts to glow.

The least energy efficient type of electronic lights typically used in residential buildings are usually called incandescent lamps. Although ineffective, incandescent lamps provide a variety of important advantages, they are inexpensive to purchase, turn on instantly and are available in a wide range of sizes and shapes.

Answer:

no it wont i think

Explanation:

Answer:

resultant force = mass × acceleration

Answer:

Resultant netforce= mass x acceleration

Explanation:

Fnet is directly proportional to acceleration, and inversly proportinal to mass.

SHOCKING

Explanation:

Answer:

D i promises.

Explanation:

light waves can go 2 direction

Answer:

F = 45 KN = 45000 N

Explanation:

Considering the downward direction as the positive direction:

[tex]P = P_1 - P_2[/tex]

where,

P = Resultant Pressure = ?

P₁ = Atmospheric Pressure = 100 KPa

P₂ = Pressure inside the can = 70000 Pa = 70 KPa

Therefore,

[tex]P = 100\ KPa - 70\ KPa\\P = 30\ KPa[/tex]

Now the resultant force will be given as:

[tex]F = PA[/tex]

where,

F = resultant force = ?

A = Area of side of can = 1.5 m²

Therefore,

[tex]F = (30\ KPa)(1.5\ m^2)\\[/tex]

F = 45 KN

Higher Power Efficiency  and Eliminates Risk of Compressor Breakdown

Answer:

When there is sudden movement on the Earth's crust, earthquakes occur. Earthquakes are caused due to sudden lateral or vertical movements in the crust of the Earth. Or we can say that when tectonic plates ride over the other and cause the collision of orogeny or mountain building.

Explanation:

Amplitude: 30 cm; wavelength 110cm.

Answer:

v = 102 m/s

Explanation:

Given that,

The frequency of a wave, f = 60 Hz

Wavelength = 1.7 m

We need to find the speed of this wave. The formula for the speed of a wave is given by

[tex]v=f\lambda[/tex]

Substitute all the values,

[tex]v=60\times 1.7\\\\v=102\ m/s[/tex]

So, the speed of the wave is equal to 102 m/s.

like a black cloud

Explanation:

Define: Signals

Before going too much further, we should talk a bit about what a signal actually is, electronic signals specifically (as opposed to traffic signals, albums by the ultimate power-trio, or a general means for communication). When one speaks of analog one often means an electrical context, however mechanical, pneumatic, hydraulic, and other systems may also convey analog signals.

An analog signal uses some property of the medium to convey the signal's information. Any information may be conveyed by an analog signal, often such a signal is a measured change in physical phenomena, such as sound, light, temperature, position, or pressure.

For example, in sound recording, changes in air pressure (that is to say, sound) strike the diaphragm of a microphone which causes related changes in a voltage or the current in an electric circuit. The voltage or the current is said to be an "analog" of the sound.

Answer:

1 meter per second

Explanation:

Every second, he walks 1 meter because 15 ÷ 15 = 1

Answer:

c. 80%

Explanation:

Given;

load raised by the machine, L = 360 N

distance through which the load was raised, d = 0.2 m

effort applied, E = 50 N

distance moved by the effort, e = 1.8 m

The efficiency of the machine is calculated as follows;

[tex]Efficiency = \frac{ 0utput \ work }{1nput \ work} \times 100\% \\\\Efficiency = \frac{Load \ \times \ distance \ moved \ by \ load }{Efort \ \times \ distance \ moved \ by \ effort} \times 100\%\\\\Efficiency = \frac{360 \times 0.2}{50 \times 1.8} \times 100\%\\\\Efficiency =80\%[/tex]

Therefore, the efficiency of the machine is 80%