Give the postional isomers of 2 halopropane
(CH3)2CH​

Answer:

Neutral

Explanation:

NaCl aqueous solution is formed by NaOH and HCl.

NaOH is a base and HCl is an acid, so they go through neutralization process forming a neutral salt and water.

Answer:

hot

Explanation:

You'll need to boil the solution, though, to reduce the amount of water so that it is concentrated enough to form crystals. Cook your solution over low to medium heat for about an hour. You want to reduce it down to 1 cup or less.

Answer:

M=93.5g/mol

Explanation:

I did this in class and it was a review. :)

The source of the forces that move the tectonic plates along this plate

boundary is the convection current in the mantle. Hence, the correct

option in option (B)

Tectonic plates refers to the Spheres that are found in the uppermost Mantle of the Earth .

The Tectonic plates are also called the Litosphere .

The Motion of the Plates about the axis causes the Tectonic demarcations which are Know as the

Convergent

Divergent

Transform

Now these Plate are formed by the Convection of Currents in the Earths's Mantle

That is, the Dynamics of Current in and around the Earths Mantle brings about the tectonic plates

Hence the the correct option in option (B)

Learn more about tectonic plates Here ;

brainly.com/question/15476626

#SPJ1

Convection currents in the mantle is the source of the forces that move the tectonic plates along this plate boundary and is denoted as option B.

This is referred to the process of heat transfer in a fluid such as gases and liquids.

The convection currents in the mantle is responsible for the force present in the tectonic plates.

Read more about Convection here https://brainly.com/question/9382711

#SPJ1

Answer:

sugar I like it I think iyrx

Answer:

As the amplitude of the sound wave increases, the intensity of the sound increases. Sounds with higher intensities are perceived to be louder. Relative sound intensities are often given in units named decibels (dB).

Explanation:

The equilibrium constant shows the extent to which reactants are converted into products.

In this case, we must find the reaction quotient as follows;

Qc = [0.55]^2/[0.12] = 2.5

Since the Qc > Kc, it means that the reverse direction is favored in this reaction.

Learn more about Kc:https://brainly.com/question/15856317

#SPJ1

Answer: Scientists make designs based on engineering knowledge and

then make it available for public use.

Answer:

3p^2

Explanation:

after filling 3s^2 only two electrons  left out of 14 so the next sub shell is 3p therefore ,X represents 3p^2

Answer: It shows whether the reaction is exothermic or endothermic.

Explanation:

Answer:

See below

Explanation:

Boiling point of water is 100 C

 this substance is higher boiling point and the molecules are likely with higher e-static forces

The unknown substance has a higher boiling point than water, and it has stronger electrostatic forces between its molecules than water. Therefore, option B is correct.

Boiling point is a measure of the temperature at which a substance changes from a liquid to a gas phase. Substances with higher boiling points generally have stronger intermolecular forces, such as hydrogen bonding or stronger dipole-dipole interactions.

Since the boiling point of the unknown substance is higher than that of water (which boils at 100°C), it suggests that the unknown substance likely has stronger electrostatic forces between its molecules compared to water.

Learn more about boiling point, here:

https://brainly.com/question/2153588

#SPJ2

Benzene be B

Toluene be T

We have made then one lettered to make things easier

[tex]\\ \rm\Rrightarrow \dfrac{P^0_B-P_B}{P^0_B}=x_B[/tex]

[tex]\\ \rm\Rrightarrow 95.1-P_B=95.(0.5)[/tex]

[tex]\\ \rm\Rrightarrow 95.1-P_B=47.55[/tex]

[tex]\\ \rm\Rrightarrow P_B=47.55mmHg[/tex]

And

[tex]\\ \rm\Rrightarrow \dfrac{P^0_T-P_T}{P^0_T}=x_T[/tex]

[tex]\\ \rm\Rrightarrow 28.4-P_T=28.4(0.5)[/tex]

[tex]\\ \rm\Rrightarrow P_T=14.2mmHg[/tex]

Total vapour pressure

Answer:

1.1: Taking Measurements. Chemists measure the properties of matter and express these measurements as quantities. A quantity is an amount of something and consists of a number and a unit. The number tells us how many (or how much), and the unit tells us what the scale of measurement is.

Answer:

because of gravitional force(gravity)........

Explanation:

2, 8, 8, 2 is the electron arrangement of Calcium.

The way that the "orbitals", the shells, fill up is given as

[tex]1s^{2} 2s^{2} 2p^{6} 3s^{2} 3p^{6} 4s^{2} 3d^{10}[/tex] . . . etc etc.

It is more stable for the fourth shell to start filling up with an electron pair, and then subsequent electrons filling up the third shell again.

So while potassium 19, is 2,8,8,1

And calcium 20, is 2,8,8,2

Scandium 21 will fill up as, 2,8,9,2

This will continue until we reach Zinc 30, which will fill up as 2,8,18,2. The third shell is now "full", and the fourth shell will now being to fill up.

The fourth orbital starts getting filled up again, Gallium 31, is 2,8,18,3

Answer:

Explanation:

4NH₃ (g) + 3O₂ (g) ⇒ 2N₂ (g) + 6H₂ O(1)

Δ[tex]H_r={\sum}{ \Delta }H_f(\text{product})-{\sum}{ \Delta }H_f(\text{reactant})[/tex]

ΔH r =(2ΔH f(N 2 )+6ΔH f (H 2 O(l)))−(4ΔH f​ (NH 3 (g))+3ΔH f (O 2 (g)))

ΔH rex =[2×0+6×(−286)]−[4×(−46)+3×0]=−1716+186

ΔH rex =−1532kJ/mol

Thermodynamics is a branch of physical chemistry that studies heat and its effects and interactions. Governed by the four main laws, thermodynamics plays a huge role in physics and chemistry, and is also responsible for the law of conservation of energy, a fundamental rule in science.

A gas that occupies 4.31 litres at a pressure of 0.755 atm will have a temperature of 39.58°C. Details about temperature can be found below.

The temperature of a gas can be calculated using the following formula:

PV = nRT

Where;

0.755 × 4.31 = 1 × 0.0821 × T

3.25 = 0.0821T

T = 3.25 ÷ 0.0821

T = 39.58°C

Therefore, a gas that occupies 4.31 litres at a pressure of 0.755 atm will have a temperature of 39.58°C.

Learn more about temperature at: https://brainly.com/question/11464844

#SPJ1

Answer:

20(50) = 40(V₂)

⇒1000 = 40V₂

⇒V₂ = 1000/40

⇒ V₂ = 25 mL

Explanation:

Answer:

25.0 mL

Explanation:

I took the test and got it right :)

Answer:

It helps compare frequencies of light.

Explanation: Hope it helps you :)))))

Have a good day.

Answer: A:  It helps compare frequencies of light.

Explanation:

Answer: Entropy is sometimes described as the degree of randomness in a system.

Answer: 0

Explanation:

If 3 electrons were to be gained, then the number of protons would equal the number of electrons.

Answer:

3/22.4

Explanation:

Answer:

V⬇2=64.mL this is the answer and the 2 is supposed to be at the bottom which the arrow stands for so do not put the arrow with that

Glycogen is formed by the loss of water molecules along the length of the polymer chain as the glucose molecules are joined together.

Glycogen is formed by a process known as condensation polymerization. This involves the loss of -OH from one glucose molecule and the loss of H from another glucose molecule as the chain is formed.

Hence, glycogen is formed by the loss of water molecules along the length of the polymer chain as the glucose molecules are joined together.

Learn more about glycogen:https://brainly.com/question/14618322

#SPJ1

The molality of the sugar solution is 0.034 mol/kg.

The molality and molarity of a chemical solution are equivalent for aqueous solutions of covalent molecules, such as sugar.

The wavelength of the radiation is 4.7 x 10⁻⁹ m

What is the Einstein's Formula for Energy?

The energy

E is given, from Einstein's formula, as:

E=h⋅ν

Where:

h=6.63×10⁻³⁴Js is Planck's constant;

ν is the frequency.

You can relate frequency and wavelength

λ through the speed of light c as:

c=λ⋅ν

So finally you get:

E=hc/λ

It is given in the question

The energy of a photon is 4.23 x 10⁻¹⁷ J.

Wavelength = ?

λ = hc/E

λ = 6.63×10⁻³⁴x 3 x 10⁸ /  4.23 x 10⁻¹⁷

λ = 4.7 x 10⁻⁹ m

Therefore the wavelength of the radiation is 4.7 x 10⁻⁹ m .

To know more about Einstein's Equation for Energy

https://brainly.com/question/3505748

#SPJ1

The mass % will be affected by 0.25%.

Mass Percentage is defined as the grams of solute per gram of solution , multiplied by 100%

It is given that

She used the pipette properly but it consistently delivered 4.70 cm³ of vinegar instead of the desired 5.00 cm³.

Mass Percentage affected = ?

Mass is directly proportional to the volume

For calculating ratios of the  same compound the density can be neglected

the density of vinegar is 1.05 gm/cm³

mass for 5cm³= 5*1.05 = 5.25gm

mass for 4.75 cm³ = 4.9875 gm

for 100 gm solution

mass% expected = 5.25* 100/100 = 5.25%

mass % (actual) = 4.9875 / (100-0.2625) = 5%

Therefore the mass % will be affected by 0.25%.

To know more about Mass Percentage

https://brainly.com/question/16885872

#SPJ1

(a) The heat generated in the process is 28 kJ.

(b) The work done in the process is determined as -28 kJ.

(c) The change in the internal energy is 0.

The heat generated in the process is negative done in the process.

W = -PΔV

W = -P(V₂ - V₁)

W = -P(VB - VA)

W = -11(7 - 12.5)

W = 60.5 L.atm = 60.5 x 101.325 J/L.atm = 6,130.16 J

W = -25(20.5 - 7)

W = -337.5 L.atm = -34,197.18 J

Total work , w = -34,197.18 J +  6,130.16 J = -28 kJ

q = - w

q = 28 kJ

ΔE = q + w

ΔE = 28 kJ - 28 kJ = 0

Learn more about change in internal energy here: https://brainly.com/question/17136958

#SPJ1

Answer:

You will typically get another chance to retake the exam

Answer:

well you either have a chance to retake the test if your teacher or just not let you take it at all. you have to pass 4 regents test including chemistry in order to get a regent diploma. so you can either retake or it you just failed it.

Answer:

Answer:

A)6.6×10^22atoms of Pt in the cube

B)1.4×10^-8m

Explanation:

(a) Calculate the number of Pt atoms in the cube.

an edge length of platinum (Pt) = 1.0 cm.

Then Volume= 1.0 cm×1.0 cm×1.0 cm=1cm^3

Then we have volume of the cube as 1cm^3

Given:

The density Pt = 21.45 g/cm3

the mass of a single Pt atom =3.240 x 10^-22 g

Then with 1atom of the platinum element, we can calculate the number of Pt atoms in the cube as

Density of pt/mass of a single Pt atom

=(21.45 /=3.240 x 10^-22)

=6.6×10^22atoms of Pt in the cube

B)Volume of cube V=4/3πr^3

V= 4/3 ×π×r^3

V= 4.19067r^3

r^3= V/4.19067

But volume is not total volume but just 74% of it, then With 74% of the space inside the cube is taken up by Pt atoms, then we need to find 74% of volume of the cube which is 1cm^3

74/100 ×1= 0.74cm^3

Then our new volume V is 0.74cm^3

r^3=0.74/4.19067×6.620 x 10^22

r^3=2.6674×10^-24

r= 3√2.6674×10^-24

r=1.4×10^-8m