Categorize the compounds below as chiral or achiral. There are 6 compounds.

Answer:

did u ever get an answer??

Explanation:

Answer:

The answer is C. Yes, because heat was produced

Answer:

C

Explanation:

Mostly all of them but most likely C

I'm glad for you! Best of luck in life tbh

Explanation:

Elements and compounds are both examples of pure substances. A substance that cannot be broken down into chemically simpler components is an element. ... A substance that can be broken down into chemically simpler components (because it has more than oneelement) is a compound.

Answer:

i need help with that too.

Explanation:

Answer:

Due to warm temperature.

Explanation:

There is water present in liquid form instead of liquid nitrogen on the outer side of the can because of the temperature present in the surrounding environment. The temperature around the can is little warm which is favourable for the water but not for the liquid nitrogen. The liquid nitrogen present in liquid state when the temperature of the surrounding is too cold. if it is warm, the liquid nitrogen starts boiling and converts into gaseous state so that's why the warmer temperature is responsible for the presence of water not the liquid nitrogen.

Answer:

The answer is "[tex]1.4 \ \bold{ billion-years}[/tex]".

Explanation:

Using formula:

[tex]\to N_{Now} = N_{orige}e^{\lambda t} \\\\[/tex]

[tex]\to[/tex] 1 U atom produces 1 Pb atom after decay.

[tex]\to[/tex] U's original numbers are now the sum of U counts and Pb counts.

 [tex]\to N_U=(N_U+N_{pb})e^{\lambda Ut}[/tex]

[tex]\to 1 = (1+3) \ exp[(\frac{-\ln(2)}{t_{(half)}} \times t ]\\\\\to t = [\frac{\ln(4)}{\ln(2)}] \times t_{(half)}[/tex]

      [tex]= 14 \times 10^8 \ \ years\\\\=1.4 \ billion \ \ years[/tex]

Answer:

They are both listed under group 11 on the periodic table and both are highly conductive of electricity

Explanation:

HOPE THIS HELPS ^^

Explanation:

For example, pH 10 is ten times more alkaline than pH 9 and 100 times (10 times 10) more alkaline than pH 8. Pure water is neutral. But when chemicals are mixed with water, the mixture can become either acidic or basic.

Answer:

idn Mann nnnnnnnn . .....mmmmm mmmm aaaaaaa it's a

The answer is Option B, NaOH is the solution student should use as the base solution in this acid-base titration experiment to determine the amount of ascorbic acid in different brands of juice.

What is an Acid Base Titration ?

An acid–base titration is a method of quantitative analysis.

It is used for determining the concentration of an acid or base by neutralizing it with a standard solution of base or acid of known concentration.

An indicator is used to monitor the progress of the acid–base reaction.

Ascorbic acid, HC₆H₇O₆ is an acid. So can be titrated with a base , sodium hydroxide, NaOH using the indicator, phenolphthalein.

HC₆H₇O₆(aq) + NaOH(aq) → NaHC₆H₇O₆(aq) + H₂O(l)

Among the options , HCl is an acid , LiBr , CaCl₂ are salts , NaOH is the only base.

Phenolphthalein changes from colorless to pink (or red) when all of the acid gets neutralized.

Therefore NaOH is the solution student should use as the base solution in this acid-base titration experiment to determine the amount of ascorbic acid in different brands of juice.

To know more about Acid Base Titration

https://brainly.com/question/15220646

#SPJ2

Answer:

The speed of the reaction

Explanation:

I just took the test and got it right... i hope this helps u :)

Answer:

83.674 grams of Fe

Explanation:

9.02 x 10²⁸ atoms

To convert from atoms to grams, we first need to convert atoms to moles. To do this, divide the atoms by Avogadro's Number, 6.02 x 10²³

9.02 x 10²⁸ ÷ 6.02 x 10²³

= 1.498 moles of Fe

Now we need to convert moles to grams. To do this, multiply the moles by the molar mass of Fe. The molar mass can be found on the periodic table.

1.498 • 55.845

= 83.674 grams of Fe

Hope this helps!

Answer:

7.22 L

Explanation:

From the question,

Applying Charles law,

V₁/T₁ = V₂/T₂...................... Equation 1

Where V₁ = Initial volume of gas, V₂ = Final volume of gas, T₁ = Initial Temperature of gas in Kelvin, T₂ = Final Temperature of gas in Kelvin

Make V₂ the subject of the equation

V₂ = (V₁×T₂)/T₁................. Equation 2

Given: V₁ = 5.00 L, T₁ = 20 °C = (20+273) K = 293 K, T₂ = 150 °C = (150+273) K = 423 K

Substitute these value into equation 2

V₂ = (5.00×423)/293

V₂ = 7.22 L

Answer:

the answer is 3(decay) and

the second isa 1(alfa particle) has a mass of equal to helium nucleus

Answer:

The formation of a gas is a clue to chemical changes. The bubbles of gas that you observed form when an antacid is dropped into water is an example of change. ... As wood burns, it turns into a pile of ashes and gases that rise into air.

Explanation:

Answer:

C

Explanation:

thats the answer!! HEHEHHEHHHHSJSKSSSSJS

Answer: B or A

Explanation: Everyone is saying C and i just took the test and it is not C

Since the molecular weight of water is about 18 g/mol, you have about 1 mol of water. So, now we know that it takes approximately 46.2 kJ of heat energy to warm 18.02g of water from 25C to 100C and then to vaporize it into steam. Hopefully this helped!

Explanation:

The would not be classified into archaea.

So, A.

Answer:

Explanation:

The density of a substance can be found by using the formula

[tex]density = \frac{mass}{volume} \\[/tex]

From the question we have

[tex]density = \frac{10}{5} = 2 \\ [/tex]

We have the final answer as

Hope this helps you

Answer:

All of them derive from a common ancestor. They each share something in their DNA that ties into their past selves, which were more closely related. As they evolved, they became more and more distant, but we can still trace them back to the olden days.

Also they all have scales.

Hope this was at least semi-useful.

Answer:

B

Explanation:

When a drought occurs, their food supply can shrink and their habitat can be damaged. Lack of food and drinking water for wild animals. Increase in disease in wild animals, because of reduced food and water supplies. Migration of wildlife.

Answer:

15900

Explanation:

I think hope this helps!! :D

Answer:

15900

Explanation:

Answer:

3.052 × 10^24 particles

Explanation:

To get the number of particles (nA) in a substance, we multiply the number of moles of the substance by Avogadro's number (6.02 × 10^23)

The mass of Li2O given in this question is as follows: 151grams.

To convert this mass value to moles, we use;

moles = mass/molar mass

Molar mass of Li2O = 6.9(2) + 16

= 13.8 + 16

= 29.8g/mol

Mole = 151/29.8g

mole = 5.07moles

number of particles (nA) of Li2O = 5.07 × 6.02 × 10^23

= 30.52 × 10^23

= 3.052 × 10^24 particles.

Answer:

Cloruro de sodio y fluoruro de sodio.

Dióxido de carbono y monóxido de hidrógeno.

Explicación:

El cloruro de sodio y el fluoruro de sodio son los compuestos que tienen enlaces iónicos. Estos compuestos iónicos se utilizan para diferentes actividades de nuestra vida diaria. El cloruro de sodio se usa para cocinar y el fluoruro de sodio se usa en la pasta de dientes para limpiar nuestros dientes. El dióxido de carbono y el monóxido de hidrógeno son compuestos que tienen enlaces covalentes. El dióxido de carbono se usa en refrescos / refrescos y algunos otros líquidos que se pueden usar en la vida diaria. El monóxido de hidrógeno es el agua pura que bebemos todos los días en nuestra vida diaria y es muy importante para nuestra supervivencia.

Answer:

Copper(II) sulphate – sodium hydroxide reaction

The reaction between copper(Il) sulphate and sodium hydroxide solutions is a good place to start. If you slowly add one to the other while stirring, you will get a precipitate of copper(II) hydroxide, Cu(OH)2.