Calculate the molarity of a Ba(OH)2 solution if 1950 mL is completely titrated by 26.1 mL of 0.505 M HNO3

% composition of ethanol = 34.51%

% composition of water  = 65.49%

A material's density is defined as its mass per unit volume.

Given data:

The density of ethanol = 0.7890 g/mL

The density of water = 0.9982 g/mL

The density of mixture = 0.926 g/mL

Let the % composition of ethanol = x

Let the % composition of water = 100-x

Now density of the mixture

[tex]\frac{Mass}{Volume}[/tex]

[tex]Mass = \frac{percent \;of \;ethanol \;X \;density \;of \;ethanol \;+ \\ \;percent \;of \;water X \;density \;of \;water}{100}[/tex]

[tex]0.926 = \frac{x X 0.7890 g/mL \;+ (100-x) X 0.9982 g/mL}{100}[/tex]

[tex]x= 34.51[/tex] %

Hence,

% composition of ethanol = 34.51%

% composition of water = 65.49%

Learn more about the density here:

https://brainly.com/question/952755

#SPJ1

Centimeters and millimeters are both interconvertible units to measure length. The conversion factor is as follows:

1 centimetre = 10 millimetres

This means that if a copper wire is 180cm long, the wire would be;

180 × 10 = 1800mm long

Also, the number of 40 mm segments of wire that can be cut from the length is calculated as follows:

1800mm/40mm = 45

Learn more about conversion at: https://brainly.com/question/12103054

#SPJ1

Answer:

If the pressure is reduced on the solid carbon dioxide the temperature will drop and the liquid carbon dioxide will solidify into snow-like substance.

Explanation:

The substitution product that is suppose to be favoured is The product with retention of configuration is expected to predominate slightly, because the leaving group blocks the nucleophile.

Substitution product is a product that is gotten from a reaction in which a group of reactant is replaced by another group in the reaction.

Therefore,The substitution product that is suppose to be favoured is The product with retention of configuration is expected to predominate slightly, because the leaving group blocks the nucleophile.

Learn more about substitution reaction below.

https://brainly.com/question/10143438

#SPJ1

The new substance will need more energy to form its chemical bonds than the old substance will release. Hence, option A is correct.

Endothermic reactions are chemical reactions in which the reactants absorb heat energy from the surroundings to form products.

Endothermic reactions, in general, are those that absorb (or use) energy. In endothermic reactions, more energy is absorbed when bonds in the reactants are broken than is released when new bonds are formed in the products.

Normally, when a chemical bond is broken, energy is released in the process. The chemical bond formation also demands an energy input.

The energy that is supplied/released can come in varieties (such as heat, light, and electricity). The formation of chemical bonds following the absorption of heat from the environment characterizes endothermic processes.

When two chemicals react in an endothermic reaction the new substance will need more energy to form its chemical bonds than the old substance will release. Hence, option A is correct.

Learn more about the endothermic reaction here:

https://brainly.com/question/23184814

#SPJ1

Answer:

Water vapor enters the atmosphere through evaporation from water bodies (oceans, seas, lakes, rivers), ice/snow cover and soil, as well as through evapotranspiration from vegetation

Explanation:

The cycle, which occurs in the troposphere, begins as the sun evaporates large amounts of water from the earth's surface and the moisture is transported to other regions by the wind. As air rises, expands, and cools, water vapor condenses and clouds develop

The equilibrium represents a buffer equilibrium is HI(aq)+H2O(l)→ H3O+(aq)+I−(aq)

Equilibrium is a process that occur in chemical reaction in which there is balance and stability. The rate of forward reaction is equal to the rate of backward reaction.

Buffer solution refer to a solution that have conjugate base and weak acid.

In buffer equilibrium, the weak acid isequal to the conjugate base be

Therefore, The equilibrium represents a buffer equilibrium

is HI(aq)+H2O(l)→ H3O+(aq)+I−(aq)

Learn more about equilibrium below.

https://brainly.com/question/517289

#SPJ1

In Chemistry, a reactivity series of metals , also known as the activity series refers to the arrangement of metals in the descending order based upon their reactivity .

Salient Features :-

The metal reactivity series is given below :-

To access the reactivity of metal , from the given reactivity series identify any of the metal and locate the reactivity based upon the choice of reactivity. The metal at the top (Potassium) is most reactive and the metal at the bottom (Platinum) is the least reactive.

To learn more about metal reactivity series visit -

https://brainly.com/question/16072297

The answer to the problem 3.96 * 0.1159 is : 0.459 (3 significant figures)

Significant figures can be defined as numbers in a group of numbers that place number in the right value or worth.

Significant figures defined the value of measurement of  a particular number.

The rules of engagement in this case is the set of rules or laid down principles that direct how we interact with this significant figures and how they are used.

For this case the significant figures of the product will be the same as the figure with the least significant figure in the multiplication.

In conclusion, The answer to the problem 3.96 * 0.1159 is : 0.459 (3 significant figures)

Learn more about Significant figures : https://brainly.com/question/24491627

#SPJ1

Answer:

Heat

Explanation:

He proved that heat was a form of energy. That is why the Joule (1 N*m or 1 kg*m^2/s^2) is the SI unit of energy. We now know that heat energy is a form of kinetic energy associated with temperature changes due to the vibrational motion in matter.

Answer:

12 banana hands + 2 bottles of chocolate syrup + 12 scoops of Breyers ice cream + 2 containers of candy cherries(30 cherries/per) +  bottle of whipped cream.

Explanation:

Hope this helps!

In this case, among the list of components given, the abiotic factors are water, rock, soil, and sun.

An abiotic factor is a non-living part of an ecosystem that shapes its environment.

Biotic and abiotic factors make up a community via interaction.

Biotic factors are considered living things (having "life") while abiotic factors are simply non-living things.

Hence, in this case, among the list of components given, the abiotic factors are water, rock, soil, sun

Learn more about the abiotic factor here:

https://brainly.com/question/10111151

#SPJ1

[tex] \begin{gathered}\\ \underline{\boxed{\large\leadsto\frak\red{ Answer :- }}} \\ \end{gathered}[/tex]

What is an abiotic factor?

♠ Among the list of components given, the abiotic factors are water, rock, soil, sun

▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬

In a simple distillation setup, the sequence of equipment from the bench top to the round bottom flask is:

This is the process in which a mixture is separated through selective boiling and condensation.

The distillation flask and liebig condenser are usually located above the round bottom flask in the set up.

Read more about Distillation here https://brainly.com/question/24553469

#SPJ4

Explanation:

the answer for the above

is b)0.019

Taking into account the scientific notation, the result of the sum is 6.6365×10⁵.

First, remember that scientific notation is a quick way to represent a number using powers of base ten.

The numbers are written as a product:

a×10ⁿ

where:

You want to add two numbers in scientific notation. It should be noted that when the numbers to be added do not have the same base 10 exponent, the base 10 power with the highest exponent must be found.

In this case, the highest exponent is 5.

Then all the values ​​are expressed as a function of the base 10 exponent with the highest exponent. In this case: 8.6500×10³= 0.086500×10⁵

Taking the quantities to the same exponent, all you have to do is add what was previously called the number "a". In this case:

0.086500×10⁵ + 6.5500×10⁵= (0.086500+ 6.5500)×10⁵=  6.6365×10⁵

Finally, the result of the sum is 6.6365×10⁵.

Learn more about scientific notation:

brainly.com/question/11403716

brainly.com/question/853571

#SPJ1

Answer:

Ba

Explanation:

Atomic radius increases going right to left, and up to down.

So the closest element to the bottom left corner is Ba.

The theoretical amount of each product obtained are:

Mg(ClO₃)₂ + 2NaOH —> Mg(OH)₂ + 2NaClO₃

From the balanced equation above,

1 mole of Mg(ClO₃)₂ reacted with 2 moles of NaOH

Therefore,

2.72 moles of Mg(ClO₃)₂ will react with = 2.72 × 2 = 5.44 moles of NaOH

From the calculation above, we can see that a higher amount (5.44 moles) of NaOH than what was given (3.14 moles) is needed to react completely with 2.72 moles of Mg(ClO₃)₂

Therefore, NaOH is the limiting reactant

From the balanced equation above,

2 moles of NaOH reacted to produce 1 mole of Mg(OH)₂

Therefore,

3.14 moles of NaOH will react to produce = 3.14 / 2 = 1.57 moles of Mg(OH)₂

Thus, the theoretical yield of Mg(OH)₂ is 1.57 moles

From the balanced equation above,

2 moles of NaOH reacted to produce 2 mole of NaClO₃

Therefore,

3.14 moles of NaOH will also react to produce 3.14 moles of NaClO₃

Thus, the theoretical yield of NaClO₃ is 3.14 moles

Learn more about stoichiometry:

brainly.com/question/14735801

#SPJ4

Answer: A

Explanation: NO CAP..................... A!!!!!!!!!!!!!!

The five components that are important are nuclear fuel consisting of fissionable material, reactor coolant, a nuclear moderator, control rods, and a shield/containment system.

Nuclear reactors are the main parts of the nuclear power plant. They run the nuclear power by initiating the nuclear reactions which produce heat.

Thus, the five components that are important are nuclear fuel consisting of fissionable material, reactor coolant, a nuclear moderator, a shield/containment system,  and control rods.

Learn more about nuclear reactor

https://brainly.com/question/13869748

#SPJ1

The concentration of the ions of the solution is 5.7 * 10^-4 M.

The ICE table can be used to determine the equilibrium constant of the process; SrSO4(s) ⇔ Sr^2+(aq) + SO4^2-(aq). ICE stands for initial, concentration and equilibrium.

Thus;

    SrSO4(s) ⇔ Sr^2+(aq) + SO4^2-(aq)

I                            0                0

C                          +x                +x

E                           x                 x

Now;

Ksp = x^2

x = √Ksp

x = √3.2 x 10-7

x = 5.7 * 10^-4 M

Learn more about Ksp:https://brainly.com/question/27132799

#SPJ4

Answer:

The answer is D.

Explanation:

Including soluble fiber into your diet can lower cholesterol levels.

Answer:

hope it helps

and give brainliest

Answer:

0.03 mol

Explanation:

The equation relating the number of moles and number of atoms is:

Number of atoms = number of moles × 6.02 × 10²³

[6.02 × 10²³ is the Avogadro's constant and is the number of particles in 1 mole of any substance.]

By rearranging the equation, we can find the number of moles of calcium.

Number of moles = (3.01 × 10²²) ÷ (6.02 × 10²³)

Number of moles = 0.05 moles of calcium

Now the only data we know about these two elements are their Mr values, so we are going to find the number of moles of magnesium using ratio.

    Moles : Mr

0.05 mol : 40.1

           x  : 24.3

[we are going to assume that x is the number of moles of magnesium that we have to find out.]

Cross multiply the ratios.

40.1x = 0.05 × 24.3

x = 1.215 ÷ 40.1 = 0.03 mol

Qualitative observations are research methods based on your senses measurable often taken using instruments only made by scientists in a laboratory

The research method in which the data is collected either by using the five senses or by measurements, In this the qualities of the substance matter and not the quantity.

The qualitative observation is subjective and so varies from person to person.

Each research using the qualitative observation will be unique.

The data is collected using one to one interaction , by questionnaires , The data is non-numerical.

Qualitative observations are research methods based on your senses measurable often taken using instruments only made by scientists in a laboratory

To know more about Qualitative Observations

https://brainly.com/question/608813

#SPJ1

Rice, pasta,sugar and chocolate tested positive for starch while water tested negative for reducing sugar.

This is an organic compound which consists of carbon, hydrogen and oxygen.

It consists of sugars, starch etc in which the food mentioned above also contain them which is why they were chosen as the appropriate choice.

Read more about Carbohydrate here https://brainly.com/question/1178789

#SPJ1

Answer:

is wrong as she fogot  to do something at the start and it is not a fair test

Explanation:

first she need to use the same with in plate second she needs to make the weighs not measure the dish third when the weighs are on 0  put your ingredient on

ps i have dislexia