7. Which object is excellent at holding onto electrons?

Answer:

true

Explanation:

np have a good day brainliest?

Answer:

[tex]3CaCl_2+2Na_3PO_4\rightarrow Ca_3(PO_4)_2+6NaCl[/tex]

Explanation:

Hey there!

In this case, according to the law of conservation of mass, it possible to balance the following reaction:

[tex]CaCl_2+Na_3PO_4\rightarrow Ca_3(PO_4)_2+NaCl[/tex]

By adding a 3 on CaCl2, a 2 on Na3PO4 and a 6 on NaCl in order to equal the atoms of calcium, chlorine, sodium, phosphorous and oxygen, as follows:

[tex]3CaCl_2+2Na_3PO_4\rightarrow Ca_3(PO_4)_2+6NaCl[/tex]

Best regards!

Answer:

Explanation: what is the question?

This is a neutralisation reaction.

Answer:

tail and fins

Explatanation:

Answer:

3.01 * 10^23 oxygen atoms

Explanation:

Water is H2O. So there are one oxygen atom for every molecule of water.

So in 5.0 mol of water molecules, there are 5.0 mol of oxygen atoms.

Since 5.0 mol = 5 * 6.02 * 10^23 molecules, there are 3.01 * 10^23 oxygen atoms.

Answer:

phototropism

Explanation:

since photo is (light?

Answer:

224.1

Explanation:

Answer:

Explanation:

Heat is a reactant.

If the equation requires heat to occur, the reaction is endothermic

The equation would have this model

A + B + heat =====> C + D

If the equation gives away heat, then it is exothermic

The equation would look like this. (I'll use a common reaction)

CH4 + 2O2 - heat ===> CO2 + 2H2O

The heat is minus when it has to be given away.

Answer:

The work was to demonstrate a repaid, precise and accurate determination method for ten trace elements (Al, Cd, Cr, Cu, Fe, Mg, Mn, Ni, Se and Zn) in periostracum serpentis (PS) and periostracum cicadae (PC) by inductively coupled plasma atomic emission spectrometry (ICP-AES). In order to evaluate the best digestion method, three different sample digestion methods including dry ashing, wet ashing and microwave digestion procedures were compared in this study.

Explanation:

Answer:

102.6 mL

Explanation:

The reaction that takes place is:

First we calculate how many NaOH moles are there in 50.00 mL of a 0.8000 M solution:

Then we convert NaOH moles into HCl moles:

Finally we calculate the volume of a 0.3900 M solution would contain 40 milimoles:

Answer:

See Explanation

Explanation:

Ionization energy refers to the energy required to remove an electron from an atom. Metals have lower ionization energy than non metals since ionization energy increases across a period.

One thing that we must have in mind is that it takes much more energy to remove an electron from an inner filled shell than it takes to remove an electron from an outermost incompletely filled shell.

Now let us consider the case of magnesium which has two outermost electrons. Between IE2 and IE3 we have now moved to an inner filled shell(IE3 refers to removal of electrons from the inner second shell) and a lot of energy is required to remove an electron from this inner filled shell, hence the jump.

For aluminium having three outermost electrons, there is a jump between IE3 and IE4 because IE4 deals with electron removal from a second inner filled shell and a lot of energy is involved in the process hence the jump.

Hence a jump occurs each time electrons are removed from an inner filled shell.

Answer:

The answer to the question is A. :)

The correct answer is Option A.

Protons and neutrons are found in the nucleus.

To learn more about atoms nucleus refer to :

https://brainly.com/question/1268608

#SPJ2

Answer:

The carbonic acid/bicarbonate buffer is the major buffer in stimulated saliva, with bicarbonate acting mainly to neutralize acids produced by bacteria when they digest sugars in the mouth or acids from the stomach. The concentration of the bicarbonate ion depends largely on the salivary flow rate.

Explanation:

Basta Yan sagut ko eh

Answer:

The carbonic acid/bicarbonate buffer is the major buffer in stimulated saliva, with bicarbonate acting mainly to neutralize acids produced by bacteria when they digest sugars in the mouth or acids from the stomach. The concentration of the bicarbonate ion depends largely on the salivary flow rate

Explanation:

Answer: The missing product in the acid base reaction is NaCl.

Explanation:

Neutralization or acid base reaction is a chemical reaction in which acid and base combine to form salt and water. Acids donate [tex]H^+[/tex] ions and bases donate [tex]OH^-[/tex] ions  in water which combine to form water molecules.

The balanced chemical reaction for the given reaction is ;

[tex]HCl+NaOH\rightarrow NaCl+H_2O[/tex]

Thus the missing product is NaCl.

The missing product in the acid-base reaction is NaCl.

The balanced chemical reaction for the given reaction is ;

[tex]HCl +NaOH[/tex] → [tex]NaCl +H_20[/tex]

When acid and base react with each other they form salt and water. Water and salt both are neutral which means, whenever acid and base react together, they are neutralized by each other.

Neutralization or acid base reaction is a chemical reaction in which acid and base combine to form salt and water.

Acids donate  [tex]H^{+}[/tex] ions and bases donate  [tex]0H^{-}[/tex] ions in water which combine to form water molecules.

Since acid and base neutralize each other's effect,it is called neutralization reaction.

For Example: When Sodium Hydroxide ( NaOH) , a base, reacts with Hydrochloric acid (HCl) , it forms the salt, Sodium Chloride (NaCl) and Water.

The balanced chemical reaction for the given reaction is ;

[tex]HCl +NaOH[/tex] → [tex]NaCl +H_20[/tex]

Thus the missing product in the acid-base reaction is NaCl.

Learn more about the neutralization reaction here:

https://brainly.com/question/22945793

#SPJ5

Answer:

the answer is ion..

hope it helps..

Answer:

The answer is high entropy.

Explanation:

Answer:

Bacteria can use sexual and asexual repoduction

Explanation:

Answer:

485 K

Explanation:

Step 1: Given data

Step 2: Calculate the final temperature of the gas

Assuming constant volume and ideal behavior, we can calculate the final temperature of the gas using Gay Lussac's law.

P₁/T₁ = P₂/T₂

T₂ = P₂ × T₁/P₁

T₂ = 200 atm × 303 K/125 atm = 485 K

Answer:

The answer is "[tex]42537.93 \ C[/tex]".

Explanation:

Molar mass : [tex]Z_n = 65.38 \ \frac{g}{mol}\\\\[/tex]

[tex]\to Zn^{2+} + 2e^{-} = Zn\\\\[/tex]

[tex]\therefore\\\\ \to 65.38 \ g \ of\ Z_n \ require: \\\\ \to 2 \times 96500\ C\\\\\to 14.41 \ g\ require,\\\\ \to \frac{(14.41 \times 2 \times 96500)}{65.38} \ \frac{g}{mol} = 42537.93 \ C[/tex]

Answer:

20.27 mol

Explanation:

454 L x (1 mol/22.4 L) = 20.27 mol

Answer: Primary consumers make up the second trophic level. They are also called herbivores. They eat primary producers—plants or algae—and nothing else. For example, a grasshopper living in the Everglades is a primary consumer

Answer:

primary consumer make up the second trophic level .they are also herbivores they eat primary consumer plants or alger and nothing else .for example a grasshopper living in the everglades is a primary consumer

Answer:

Most ionic compounds are soluble in water. Polar water molecules have a strong attraction for charged ions and the charged ions become solvated as they dissociate into water and ionic compounds are soluble in water.

Answer:

First balance the equation

C2H6 + 7/2O2 2CO2 +3H2O

for one mole of C2H6 there are 7/2 mole of O2 required. so for4.50 moles you require 4.50 x 7/2 = 15.75 moles of O2.

Explanation:

Answer:

0.030

Explanation:

Step 1: Write the balanced reaction at equilibrium

CaCO₃(s) ⇌ CaO(s) + CO₂(g)

Step 2: Calculate the concentration equilibrium constant

The concentration equilibrium constant (Kc) is equal to the product of the concentrations of the products raised to their stoichiometric coefficients divided by the product of the concentrations of the reactants raised to their stoichiometric coefficients. It doesn't include solids or pure liquids.

Kc = [CO₂] = 0.030

Answer:

1) 0 C2H4O2 + 0 O2 -> 0 CO2 + 0 H2O (balanced)

2) V2O5 + CaS -> CaO + V2S5

just additional info: V2O5 is divanadium pentaoxide

LHS (Left hand side)

V: 2

O: 5

Ca: 1

S: 1 x 5 [to balance with the right hand side of the equation]

RHS (Right hand side)

V: 2

O: 1 x 5 [to balance with the left hand side of the equation]

Ca: 1

S: 5

When you balance any elements, you have to balance the whole chemical compound.

Thus,

V2O5 + 5 CaS -> 5 CaO + V2S5

LHS CHECK:

V: 2

O: 5

Ca: 5

S: 5

RHS CHECK:

V: 2

O: 5

Ca: 5

S: 5

3) S8 + O2 -> SO2

LHS:

S: 8

O: 2

RHS:

S: 1 x 8 [to balance with LHS]

O: 2

When you balance any elements, you have to balance the whole chemical compound.

S8 + O2 -> 8 SO2

When we add 8 to the RHS, it gives us 8S, 16 O.

In order to balance that into the RHS, I need to multiply the O2 by 8, which will give 8(O2) = 16 O particles.

Therefore, S8 + 8 O2 -> 8 SO2 is the final answer for (3).

Answer:

1. The energy of the reactant is 50 KJ

2. The energy of the product is 100 KJ

3. The activation energy of the forward reaction is 200 KJ.

4. The activation energy of the reverse reaction is 150 KJ.

5. The energy of the forward reaction is +50 KJ

6. The energy of the reverse reaction is –50 KJ

7. Endothermic reaction

8. Exothermic reaction

Explanation:

1. Determination of the energy of reactant.

From the diagram given above, the energy of the reactant is 50 KJ

2. Determination of the energy of product.

From the diagram given above, the energy of the product is 100 KJ.

3. Determination of the activation energy of the forward reaction.

The activation energy is the energy between the reactant and the peak. It can be obtained as follow:

Energy of reactant (Eᵣ) = 50 KJ

Energy at the peak (Eₕ) = 250 KJ

Activation energy (Eₐ) =?

Eₐ = Eₕ – Eᵣ

Eₐ = 250 – 50

Eₐ = 200 KJ

Thus, the activation energy of the forward reaction is 200 KJ

4. Determination of the activation energy of the reverse reaction.

Energy of reactant (Eᵣ) = 100 KJ

Energy at the peak (Eₕ) = 250 KJ

Activation energy (Eₐ) =?

Eₐ = Eₕ – Eᵣ

Eₐ = 250 – 100

Eₐ = 150 KJ

Thus, the activation energy of the reverse reaction is 150 KJ

5. Determination of the energy of the forward reaction.

Energy of reactant (Eᵣ) = 50 KJ

Energy of product (Eₚ) = 100 KJ

Enthalpy change (ΔH) =?

ΔH = Eₚ – Eᵣ

ΔH = 100 – 50

ΔH = +50 KJ

Thus, the energy of the forward reaction is +50 KJ

6. Determination of the energy of the reverse reaction.

Energy of reactant (Eᵣ) = 100 KJ

Energy of product (Eₚ) = 50 KJ

Enthalpy change (ΔH) =?

ΔH = Eₚ – Eᵣ

ΔH = 50 – 100

ΔH = –50 KJ

Thus, the energy of the reverse reaction is –50 KJ

7. The forward reaction is endothermic reaction because the energy of the product is higher than the energy of the reactant which leads to positive energy of the forward reaction (+50 KJ).

8. The reverse reaction is exothermic reaction because the energy of the product is lesser than the energy of the reactant which leads to negative energy of the reverse reaction (–50 KJ). In a nut shell, we can say that the energy of the reverse reaction is exothermic because its energy of reaction is –50 KJ.

Answer:

Explanation:

Answer:

b

Explanation:

learned this in science class